HVAC Comfort Club Plan
<< Scroll sideways to view more >>
| HVAC Comfort Club Plan | Annual | Monthly |
|---|---|---|
| 25-Point Annual Maintenance | ||
| Reminder Service | ||
| HVAC Repair Discount | 15% | |
| Repair Warranty | 3 yrs | |
| Priority Service | within 24hs | |
| Trip/Diagnostic Fee | 50% off | |
| Loyalty Credits | $50/yr | |
| Add-ons | Annual | Monthly |
| Humidifier | $40 | $4 |
| Electronic Air Cleaner | $40 | $4 |
| Standard Water Heater | $40 | $4 |
Humidifier
- Inspect & Clean Unit
- Replace Humidifier Pad
- Test Safety Controls
- Test Operating Controls
Electronic Air Cleaner
- Inspect & Clean Unit
- Replace Humidifier Pad
- Test Safety Controls
- Test Operating Controls
Standard Water Heater
- Perform Multi-Point Inspection
- Clean Unit
- Test Safety Controls
- Test Operating Controls
<< Scroll sideways to view more >>
| Annually (Save 20%) | Monthly (Auto-pay only) | |
|---|---|---|
| Gas Furnace/Boiler | $150 | $15 |
| Oil Furnace/Boiler | $230 | $23 |
| Tankless Water Heater | $150 | $15 |
| AC/Heat Pump | $150+tax | $15+tax |
25-Point Annual Maintenance Task Lists
Gas Furnace - 25 pt Maintenance
- Adjust fan speed for proper airflow
- Check equipment grounding
- Clean & inspect inducer fan motor & blower assembly
- Clean & tighten electrical connections as needed
- Clean and inspect furnace heat exchanger
- Clean burners & flame sensor
- Inspect cabinet, cabinet fasteners & panels
- Inspect electrical connections & wires
- Inspect electrical disconnect box
- Inspect & record ohm reading on hot surface igniter
- Inspect & test contactors & relays
- Inspect inlet & exhaust vent pipe
- Inspect vent connectors
- Inspect vent exhaust
- Inspect visible fuel connections
- Inspect & clean condensate pump, drains & traps
- Test zoning controls modes of operation & bypass dampers
- Test capacitors
- Replace standard air filter
- Test safety control operations, sequences & ranges
- Test thermostat operation
- Lubricate all moving parts
- Measure/record line voltage & amp draw to blower motor
- Perform combustion analysis test
- Visually inspect ductwork & check for moisture accumulation
AC/Heat Pump - 25 Pt Maintenance
- Adjust fan speed for proper airflow
- Check equipment grounding
- Clean & inspect inducer fan motor & blower assembly
- Clean & tighten electrical connections as needed
- Test refrigerant charge
- Inspect & clean condensate pump, drain & traps
- Inspect & test contactors & relays
- Inspect cabinet, cabinet fasteners & panels
- Inspect electrical connections & wires
- Inspect electrical disconnect box
- Lubricate all moving parts
- Replace standard air filter
- Measure/record line voltage & AMP draw to blower motor
- Test capacitors
- Test safety control operations, controlsequences & test ranges
- Test thermostat operation
- Test zoning controls modes of operation & bypass dampers
- Visually inspect ductwork for integrity or moisture accumulation
- Clean inside evaporator coil as needed
- (w/ maint.)
- Clean outside condensing coil
- Inspect fan belt tension
- Inspect indoor & outdoor coils for dirt buildup
- Measure & record condenser fan motor and compressor amps & volts
- Record indoor coil entering & leavingtemperature
- Rinse outdoor coil
Oil Furnace - 25 Pt Maintenance
- Check equipment grounding
- Clean & tighten electrical connections as needed
- Clean and inspect furnace heat exchanger
- Combustion analysis test
- Replace oil nozzle, tank filter and pump strainer
- Inspect & test contactors & relays
- Inspect cabinet, cabinet fasteners & panels
- Inspect electrical disconnect box
- Inspect vent connectors
- Inspect vent exhaust
- Inspect visible fuel connections
- Lubricate all moving parts
- Measure/record line voltage & AMP draw to blower motor
- Replace standard air filter
- Test capacitors
- Test safety control operations, control sequences & test ranges
- Test thermostat operation
- Visually inspect ductwork for integrity or moisture accumulation
- Brush & vacuum heat exchanger
- Check oil pump pressure
- Inspect & clean* flue pipe
- Inspect belt & pulleys for wear and tear
- Inspect condition of oil tank and stick for water
- Inspect fan belt tension
- Verify flue draft
Plumbing Comfort Club Plan
<< Scroll sideways to view more >>
| Plumbing Plan | $160/yr (Save 20%) |
$16/mo |
|---|---|---|
| Indoor Plumbing Visual Inspection | ||
| Plumbing Repair Discount | 15% off | |
| Priority Service | Within 24 hrs | |
| Trip/Diagnostic Fee | 50% off | |
| Loyalty Credits | $50/yr | |
| Water Heater | 10% off | |
| Add-ons | Annual (Save 20%) | Monthly |
| Descale tankless water heater with Maintenance | $195 | $19.50 |
| Camera inspection of main sewer line up to 100ft form outside clean-out | $195 | $19.50 |
| Chain-knocker main line sweep up to 100ft | $195 | $19.50 |
| Standard tank water heater flush | $40 | $4 |
Indoor Visual Inspection Task List
- Tag valves and water main
- Emergency shut-off valves
- All exposed plumbing pipes
- Tubs and stalls
- Any applicable filters
- Drainage connections/traps
- Water softener
- Exterior hose bibs
- Pressure reducing valve
- Garbage disposal
- Toilet connections and operations
- All faucets and sinks
- Water Main
- Appliance and fixture connections, washing machine, dishwasher, refrigerator, etc.